The short version of Porous cake fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2025-11-25 and is reviewed periodically as new material appears.
Freeze-drying is distinct from simple evaporation and from spray drying. Evaporation removes water at temperatures above freezing, while spray drying rapidly dries droplets in a heated gas stream. Lyophilization avoids high temperatures, which can be useful for heat-sensitive materials such as proteins, vaccines, and some foods. The porous cake produced by sublimation dissolves or rehydrates more quickly than a dense dried mass. Not all materials tolerate freezing or the pH shifts that can occur as solutes concentrate during ice formation.
Lyophilization removes water from a frozen material by sublimation under reduced pressure. The process begins with freezing, which converts liquid water into ice and fixes the structure of the sample. After freezing, primary drying lowers pressure so ice changes directly to vapor without passing through a liquid phase. Secondary drying then removes bound water that remains after ice sublimation. The result is a dry, porous solid that often retains its original shape.
The low pressure used during drying allows water vapor to move from the ice surface to a cold condenser. Energy supplied as heat drives sublimation but must stay below the collapse temperature of the frozen matrix. If the product becomes too warm, the frozen structure may soften or melt, reducing pore formation and slowing drying. Formulations often include bulking agents, stabilizers, or buffers to support a rigid cake. The final moisture content depends on formulation, freezing rate, and the length of secondary drying.
Freezing determines ice crystal structure and pore size, which affect drying speed and product uniformity. Rapid freezing creates small crystals, while slow freezing creates larger crystals and often faster sublimation. During primary drying, chamber pressure is held below the vapor pressure of ice, and shelf temperature supplies heat for sublimation. The ice front recedes, leaving a porous matrix. Thermal limits such as collapse and eutectic temperatures set safe boundaries for formulation. These limits vary with solute composition and concentration.
Secondary drying removes bound water that remains after ice sublimation. Shelf temperature is raised gradually while pressure remains low, reducing water content to a target range. Over-drying can cause brittleness or electrostatic issues, while under-drying affects stability. The endpoint is often judged by pressure rise tests, temperature measurements, or water content analysis. Scale-up depends on matching heat and mass transfer across equipment sizes. Small changes in shelf temperature or pressure can alter cycle length substantially.
| Property | Value | Notes |
|---|---|---|
| Primary phase change | Sublimation | Ice changes directly to vapor under reduced pressure |
| Typical chamber pressure | 0.01–0.5 mbar (1–50 Pa) | Below the triple point of water; product-specific |
| Typical product temperature during primary drying | −40 °C to −10 °C | Kept below collapse temperature |
| Typical residual moisture | 0.5–3% w/w | Target range varies by formulation and use |
| Common synonyms | Freeze-drying; lyophilisation | Lyophilization is the US spelling |
The physical chemistry of freezing influences whether a formulation forms an amorphous glass or a crystalline solid. Amorphous systems can collapse if product temperature rises above the glass transition temperature of the freeze concentrate. Crystalline systems may show eutectic melting, where ice and solute melt together at a fixed temperature. Formulators add bulking agents, lyoprotectants, and buffers to preserve structure and biological activity. The optimum cycle keeps product temperature below critical thresholds during primary drying while allowing efficient sublimation.
Lyophilization is a dehydration process that removes water from a frozen material by sublimation under low pressure. The material is first frozen so that water becomes ice; then the surrounding pressure is lowered below the vapor pressure of ice. Heat is applied gently so ice changes directly to vapor without passing through a bulk liquid phase. The vapor is collected on a cold condenser, leaving a dry porous matrix. This process differs from simple evaporation because the material remains frozen during the main drying stage.
In practice, lyophilization is slower and more energy intensive than simple drying. Cycle times can range from hours to several days depending on load, container, and formulation. Amorphous materials may require excipients that help preserve structure during freezing and drying. The method is widely used for biological materials, pharmaceuticals, and foods where heat drying would cause unacceptable change. Open questions remain about scaling cycles between laboratory and production equipment, and this gap affects technology transfer.
Lyophilization removes water by freezing a material and then lowering pressure so ice changes directly to vapor. The process relies on sublimation, the phase transition from solid to gas without an intermediate liquid state. Because the material remains frozen during primary drying, the structure often stays porous. This porous matrix can rehydrate quickly when water is added back. The low pressure also allows vapor to leave the solid matrix without boiling.
Korsmeyer Award, ASCI (2008) Distinguished Leader in Insulin Resistance Award (2008) Elected Fellow, American Association for the Advancement of Science (2009) Outstanding Clinical Investigator Award, Endocrine Society (2012) Sir Philip Randle Award, Biochemical Society (2013) Elected to Master, American Association of Clinical Endocrinology (2015) Solomon Berson Award, American Physiological Society (2016) Harrington Scholar-Innovator (2016) Inaugural Fellow, American Physiological Society (2016) Distinguished Alumni Award, Wayne State University (2016) Banting Medal for Lifetime Scientific Achievement, American Diabetes Association (2018) Elected to the American Academy of Arts and Sciences (2018) Arthur Riggs Award, City of Hope (2019) Stanley Mirsky Award, Icahn School of Medicine at Mount Sinai (2019) Samuel Eichold II Memorial Award, American College of Physicians (2020) Manpei Suzuki International Prize for Diabetes Research (2021) Elected to Master, American College of Physicians (2021) Fellow of the Royal College of Physicians (2021) EASD-Lilly Centennial Anniversary Prize for Landmark Discoveries in Diabetes, European Association for the Study of Diabetes (2023) Bodil Schmidt-Nielsen Distinguished Mentor and Scientist Award, American Physiological Society (2024) EASD-Novo Nordisk Foundation Diabetes Prize for Excellence (2025)
On 1 July 2021, finance officials from 130 countries agreed on plans for a new international taxation policy known as the global minimum corporate tax (of 15%). If a country taxes a multinational at a lower rate, the multinational's HQ will receive the difference. All the major economies agreed to pass national laws that would require corporations to pay at least 15% income tax in the countries they operate. This new policy would end the practice of locating world headquarters in small countries with very low taxation rates. Governments hope to recoup some of the lost revenue, estimated at $100 billion to $240 billion each year. The new system was promoted by the Biden Administration in the United States and the OECD. Secretary-General Mathias Cormann of the OECD said, "This historic package will ensure that large multinational companies pay their fair share of tax everywhere."
=== Early corals === Reef-building organisms similar to modern corals first appeared in the Cambrian about 535 million years ago. Fossils are extremely rare until the Ordovician period, 100 million years later, when Heliolitida, rugose, and tabulate corals became widespread. Paleozoic corals often contained numerous endobiotic symbionts. Tabulate corals occur in limestones and calcareous shales of the Ordovician period, with a gap in the fossil record due to extinction events at the end of the Ordovician. Corals reappeared some millions of years later during the Silurian period, and tabulate corals often form low cushions or branching masses of calcite alongside rugose corals. Tabulate coral numbers began to decline during the middle of the Silurian period. Rugose or horn corals became dominant by the middle of the Silurian period, and during the Devonian, corals flourished with more than 200 genera. The rugose corals existed in solitary and colonial forms, and were also composed of calcite. Both rugose and tabulate corals became extinct in the Permian–Triassic extinction event 250 million years ago (along with 85% of marine species), and there is a gap of tens of millions of years until new forms of coral evolved in the Triassic.
=== Mechanism of action === Gepotidacin's primary mechanism of action involves inhibiting bacterial DNA replication, specifically targeting DNA gyrase (topoisomerase II) and topoisomerase IV. These enzymes are vital for bacterial processes such as replication, transcription, and cell division, as they regulate the topological state of DNA during these activities. Gepotidacin binds to the GyrA subunit of DNA gyrase and the ParC subunit of topoisomerase IV. Research has shown that this interaction occurs within a pocket formed by these subunits, located between the scissile DNA bonds. By binding in this region, gepotidacin inhibits the activity of these enzymes, thereby impairing bacterial replication. This mechanism of action is distinct from other antibiotic classes, including fluoroquinolones.
Sources: en.wikipedia.org
== Life cycle == Like many species of bamboo, black bamboo synchronizes its flowering, with flowering events happening every 40-120 years. According to one source, it has bloomed every 120 years "since records have been kept". It is monocarpic, that is, after flowering, the plants die. Henon bamboo flowers every 120 years and is predicted to flower in the 2020s. Since it is widely distributed in Japan, dieback of its stands may cause serious social and environmental problems. Moreover, Henon bamboo rarely sets fertile seeds, so it is not clear how this species has survived over long periods in Japan.
=== Other === The muscles that control breathing and limb movements can also be affected; rarely do these present as the first symptoms of myasthenia gravis, but develop over months to years. In a myasthenic crisis, a paralysis of the respiratory muscles occurs, necessitating assisted ventilation to sustain life. Crises may be triggered by various biological stressors such as infection, fever, an adverse reaction to medication, or emotional stress.
Phenyl groups are found in many organic compounds, both natural and synthetic (see figure). Most common among natural products is the amino acid phenylalanine, which contains a phenyl group. A major product of the petrochemical industry is "BTX" consisting of benzene, toluene, and xylene - all of which are building blocks for phenyl compounds. The polymer polystyrene is derived from a phenyl-containing monomer and owes its properties to the rigidity and hydrophobicity of the phenyl groups. Many drugs as well as many pollutants contain phenyl rings. One of the simplest phenyl-containing compounds is phenol, C6H5OH. It is often said the resonance stability of phenol makes it a stronger acid than that of aliphatic alcohols such as ethanol (pKa = 10 vs. 16–18). However, a significant contribution is the greater electronegativity of the sp2 alpha carbon in phenol compared to the sp3 alpha carbon in aliphatic alcohols.
Female spotted hyenas exposed to larger doses of androgen have significantly damaged ovaries, making it difficult to conceive. After giving birth, the pseudo-penis is stretched and loses much of its original aspects; it becomes a slack-walled and reduced prepuce with an enlarged orifice with split lips. Approximately 15% of the females die during their first time giving birth, and over 60% of their species' firstborn young die. A 2006 Baskin et al. study concluded, "The basic anatomical structures of the corporeal bodies in both sexes of humans and spotted hyenas were similar. As in humans, the dorsal nerve distribution was unique in being devoid of nerves at the 12 o'clock position in the penis and clitoris of the spotted hyena" and that "[d]orsal nerves of the penis/clitoris in humans and male spotted hyenas tracked along both sides of the corporeal body to the corpus spongiosum at the 5 and 7 o'clock positions. The dorsal nerves penetrated the corporeal body and distally the glans in the hyena", and in female hyenas, "the dorsal nerves fanned out laterally on the clitoral body. Glans morphology was different in appearance in both sexes, being wide and blunt in the female and tapered in the male".
In this pathway, PAH molecules bind to the aryl hydrocarbon receptor (AhR) and activate it as a transcription factor that increases production of the cytochrome enzymes. The activity of these enzymes may at times conversely protect against PAH toxicity, which is not yet well understood. Low molecular weight PAHs, with two to four aromatic hydrocarbon rings, are more potent as co-carcinogens during the promotional stage of cancer. In this stage, an initiated cell (a cell that has retained a carcinogenic mutation in a key gene related to cell replication) is removed from growth-suppressing signals from its neighboring cells and begins to clonally replicate. Low-molecular-weight PAHs that have bay or bay-like regions can dysregulate gap junction channels, interfering with intercellular communication, and also affect mitogen-activated protein kinases that activate transcription factors involved in cell proliferation. Closure of gap junction protein channels is a normal precursor to cell division. Excessive closure of these channels after exposure to PAHs results in removing a cell from the normal growth-regulating signals imposed by its local community of cells, thus allowing initiated cancerous cells to replicate. These PAHs do not need to be enzymatically metabolized first. Low molecular weight PAHs are prevalent in the environment, thus posing a significant risk to human health at the promotional phases of cancer.
Sources: en.wikipedia.org
Lyophilization relies on sublimation, so water moves from solid ice to vapor without becoming liquid. The material is frozen, pressure is reduced, and controlled heat is supplied. Vapor is captured on a cold condenser, leaving a dry porous solid.
The process has three main stages: freezing, primary drying, and secondary drying. Freezing sets the ice structure, primary drying removes free ice, and secondary drying removes bound water. Each stage uses specific temperature, pressure, and time settings.
No, it is a drying method rather than a sterilization method. Removing water can limit microbial growth, but it does not reliably kill microorganisms. Sterility must come from separate steps such as filtration, heat treatment, or aseptic processing.
Conventional drying uses heat to evaporate liquid water, often at temperatures that can degrade sensitive materials. Lyophilization freezes the material first and then removes water by sublimation under vacuum. This avoids prolonged exposure to liquid water and high heat.